The enhanced formula of ProtectAll Rubber Roof Treatment is proven to stop roof chalking, minimize maintenance and provide additional protection of the RV’s rubber roof membrane.

Every application coats the EPDM roof with a tough polymer which creates an anti-static barrier, reducing the chalking and repelling dirt.

The treatment is easily applied in three steps:

Step 1: Clean the RV roof thoroughly and allow it to dry properly – A less strenuous method of cleaning the roof is by using ProtectAll Rubber Roof Cleaner, which only requires a sponge mop and a bucket of water. This method allows you to clean the roof without rinsing it, reducing the time spent cleaning. Step 2: Apply the product on a 2 to 3 sq. ft. section and use a clean sponge mop to spread the treatment evenly Step 3: For best results, allow the rubber roof to air dry and cure for at least 24 hours.

Note: Allow the roof to dry completely before walking on it. If possible, do not treat the roof right before it rains and only apply it in temperatures between 55 and 90 degrees. If the roof is too hot, the treatment may begin drying before spreading.

One treatment lasts approximately 3 to 6 months, depending on the climate. In cooler, dry climates the treatment will last longer than in climates with excessive moisture, heat, and sun.

Highlights:

VERSATILITY: ProtectAll Rubber Roof Treatment with UV Protection is easy to apply on any EPDM rubber roof PERFORMANCE: The formula coats the roof in a tough polymer with anti-static properties, preventing grime from sticking and reducing the powdery roof chalk that causes gray streaks CONVENIENCE: Reduces maintenance up to 75% – More protection, less cleaning required UTILITY: Provides a barrier against UV light and against the elements, repelling dirt and grime